|
HTML rendering created 2024-06-26 by Michael Kerrisk, author of The Linux Programming Interface. For details of in-depth Linux/UNIX system programming training courses that I teach, look here. Hosting by jambit GmbH. |
|
|
NAME | SYNOPSIS | DESCRIPTION | OPTIONS | PCP ENVIRONMENT | SEE ALSO | COLOPHON |
|
|
|
PMSIGNAL(1) General Commands Manual PMSIGNAL(1)
pmsignal - send a signal to one or more processes
$PCP_BINADM_DIR/pmsignal [-alnp] [-s signal] [PID ...|name ...]
pmsignal provides a cross-platform event signalling mechanism for
use with tools from the Performance Co-Pilot toolkit. It can be
used to send a named signal (only HUP, USR1, TERM, and KILL are
accepted) to one or more processes.
The processes are specified directly using PIDs or as program
names (with either the -a or -p options). In the all case, the
set of all running processes is searched for a basename(1) match
on name. In the program case, process identifiers are extracted
from files in the $PCP_RUN_DIR directory where file names are
matched on name.pid.
The -n option reports the list of process identifiers that would
have been signalled, but no signals are actually sent.
If a signal is not specified, then the TERM signal will be sent.
The list of supported signals is reported when using the -l
option.
On Linux and UNIX platforms, pmsignal is a simple wrapper around
the kill(1) command. On Windows, the is no direct equivalent to
this mechanism, and so an alternate mechanism has been
implemented - this is only honoured by PCP tools, however, not
all Windows utilities.
The available command line options are:
-a, --all
Send signal to all named processes.
-l, --list
List supported signals.
-n, --dry-run
List processes that would be affected.
-p, --program
Extract programs from PCP runtime PID files.
-s signal, --signal=signal
Specify the signal to send, one of: HUP, USR1, TERM, KILL.
-?, --help
Display usage message and exit.
Environment variables with the prefix PCP_ are used to
parameterize the file and directory names used by PCP. On each
installation, the file /etc/pcp.conf contains the local values
for these variables. The $PCP_CONF variable may be used to
specify an alternative configuration file, as described in
pcp.conf(5).
basename(1), kill(1), killall(1), pcp.conf(5) and pcp.env(5).
This page is part of the PCP (Performance Co-Pilot) project.
Information about the project can be found at
⟨http://www.pcp.io/⟩. If you have a bug report for this manual
page, send it to [email protected]. This page was obtained from the
project's upstream Git repository
⟨https://github.com/performancecopilot/pcp.git⟩ on 2024-06-14.
(At that time, the date of the most recent commit that was found
in the repository was 2024-06-14.) If you discover any rendering
problems in this HTML version of the page, or you believe there
is a better or more up-to-date source for the page, or you have
corrections or improvements to the information in this COLOPHON
(which is not part of the original manual page), send a mail to
[email protected]
Performance Co-Pilot PCP PMSIGNAL(1)
Pages that refer to this page: pmcd(1)
|
HTML rendering created 2024-06-26 by Michael Kerrisk, author of The Linux Programming Interface. For details of in-depth Linux/UNIX system programming training courses that I teach, look here. Hosting by jambit GmbH. |
|